Hi guys!
I hope I can find some help here. I recently purchased this card from ebay: "New-Martzis-CNC-Mach3-USB-HID-Interface-Card-USB-Board-Mach3-and-Lunix-EMC-/361606154039"
It works perfectly except I have a problem with the encoder inputs. I have uploaded a video to demonstrate this.
https://youtu.be/Nxb837eGLnQ
As you can see the axis only goes up, but it cannot go down. For my purpose I need the encoder to be in 1x mode and count both rising edges and falling edges. Is this possible? I want to use this for flight simulation to control my radios, so I need it to go up and down too.
I would appreciate any help I can get.
Hei kaverit!
Toivon, että voin löytää apua. Olen hiljattain ostanut tämän kortin eBay : "New-Martzis-CNC-Mach3-USB-HID-Interface-Card-USB-Board-Mach3-and-Lunix-EMC-/361606154039"
Se toimii täydellisesti paitsi minulla on ongelma Encoder panoksia. Olen ladannut videon tämän osoittamiseksi.
https://youtu.be/Nxb837eGLnQ
Kuten näet akselin vain menee ylös , mutta se ei voi mennä alas . Minun tarkoitukseen Tarvitsen kooderi olla 1x -tilassa ja laske molemmat nousevat reunat ja laskevat reunat . Onko tämä mahdollista? Haluan käyttää tätä varten lentosimulointi valvoa minun radiot , joten minun täytyy se mennä ylös ja alas liikaa.
Olisin kiitollinen apua saan .